Bead and Mesh
Beads designed to give true corners and edges to plaster and render internally and externally for all conditions; finishing with good resistance to cracking, chipping and impact damage on corners and edges. Standard and security grade mesh products used as a key for plaster internally and render externally and can be fixed to brick / block work, timber, steel and concrete using various proprietary fixings to provide a smooth even finish where required.
GPS Galvanised Plaster Stop Bead
Plaster and render bead. Provides a straight and clean edge to wet plaster where it butts up to other materials such as door and window frames. Fixed with plaster or mortar dabs as above or can be nailed. Generally for internal use only. Stainless Steel or PVC-u. Recommended for external use.
View product
GERS Galvanised External Render Stop (Bell) Bead
Plaster and render bead. Used where a neat drip or ‘bell-end’ lower edge is needed on external render. Fixed by mortar dabs or masonry nails. Although this is for external use we would generally recommend Stainless Steel or PVC-u for this application only using this product in sheltered or low rainfall areas.
View product
GMB Galvanised Movement Bead
Plaster and render bead. Designed to be used to form movement joints in plaster or render where long wall runs either have movement joints in situ or where there is a need to allow for differential or thermal movement. The bead consists of two plaster stop lengths joined by a white pvc extrusion which allows for up to 4mm of movement and which is covered by a vinyl tape which is removed after plastering or rendering. Internal use only. We recommend Stainless Steel or PVC-u for external rendering.
View product
GARB Galvanised Architrave Bead
A range of beads produced to allow for decorative finishes – i.e. shadow lines and recesses around door and window frames etc. The bead can either be supplied as an engaging bead or abutting bead with various plaster depths available. Internal use only.
View product
SAB Stainless Steel Angle Bead
External bead. The traditional render corner bead provides a strong true corner or arris, with the mesh wings allowing for a good plaster key and resistance to cracking. Fixed by mortar dabs at approximately 600mm centres, push the wings into the dabs to allow for the required render depth, up to 13mm, then ensure the nose is set square and plumb as required.
View product
SPS Stainless Steel Plaster Stop
External bead. Provides a straight and clean edge to render where it butts up to other materials such as door and window frames. Fixed with mortar dabs as above or can be nailed using stainless steel fixings.
View product
SERS Stainless Steel External Render (Bell) Bead
External bead. Used where a neat drip or ‘bell-end’ lower edge is needed on external render. Fixed by mortar dabs or stainless steel nails.
SMB Stainless Steel Movement Bead
External bead. Designed to be used to form movement joints in plaster or render where long wall runs either have movement joints in situ or where there is a need to allow for differential or thermal movement. The bead consists of two plaster stop lengths joined by a white pvc extrusion which allows for up to 4mm of movement and which is covered by a vinyl tape which is removed after plastering or rendering.
View product
PAB 23 PVC-u Angle Bead Thincoat
A PVC-u equivalent to a mini mesh or perforated thin coat bead for use with plasterboard where a skim coat is required. Fixed using drywall nails or jointing filler the profile allows for a 2mm to 3mm plaster coat to provide a neat corner edge. Internal use only.
View product